Nexelec MOUNT Universal mounting base (Pack of 50)
MCCI P/N
123004188
Nexelec P/N
S004-PRO
—
$ 79.00
—
The Nexelec MOUNT is a universal mounting base designed for retrofitting Nexelec detectors onto existing wall or ceiling fixing points from other brands — without drilling new holes. Compatible with a wide range of mounting hole spacings, MOUNT is sold in packs of 50 and is designed for large-scale renovation deployments.
MOUNT is made from polycarbonate plastic with a low profile (100 × 100 × 2 mm). It attaches with screws and plugs (included) or with the optional TAPE adhesive fastener. A lockable design reduces the risk of detector removal in rental accommodation.
Key Features
- Universal retrofit base: Covers existing screw holes from other brands of detectors. Wide mounting center spacing accommodates a broad range of previous fixing positions — no new drilling required in most cases.
- Quick installation: Unscrew the old detector base, screw MOUNT in its place using the existing holes. Takes approximately 1 minute per unit.
- Lockable mounting: Base locks to reduce the risk of detector removal in rental housing and managed properties.
- TAPE adhesive compatible: Can be installed without screws using the Nexelec TAPE adhesive fastener (sold separately) — approved for EN14604/EN50291/NF292 certified detectors.
- Certified installation device: Approved for use with Nexelec INSAFE (smoke) and SECURE (CO) detectors certified to EN14604, EN50291, and NF292.
- Professional pack: Sold in packs of 50 bases (reference S004-PRO).
Applications
- Replacement of other brands' smoke or CO detectors with Nexelec INSAFE or SECURE units in rental housing and managed properties
- Large-scale renovation deployments where existing mounting holes must be reused
- Installations where drilling new holes is not permitted or practical
Installation
- Remove the old detector from its existing base.
- Unscrew the old base from the wall or ceiling.
- Position MOUNT over the existing holes and screw in place using the supplied screws and plugs, or use the TAPE adhesive fastener (sold separately).
- Position the Nexelec detector on the MOUNT base and turn a quarter turn to the right to lock it in place.
Important Notes
- Compatible with Nexelec INSAFE (smoke) and SECURE (CO) detectors only. Not compatible with the room sensor range (FEEL, MOVE, RISE, etc.).
- AFNOR Certification recommends fixing detectors with screws and plugs. Refer to the "Installation" section of the Nexelec user manual for your specific detector.
- TAPE adhesive fastener is an optional accessory sold separately (S003-PRO, pack of 100).
Specifications
| Mechanical | |
| Material | Polycarbonate plastic |
| Dimensions | 100 × 100 × 2 mm |
| Mounting | Wall or ceiling; screws and plugs included |
| Adhesive compatible | Nexelec TAPE (S003-PRO, sold separately) |
| Anti-tamper | Lockable base |
| Environmental | |
| Operating temperature | −10°C to +50°C |
| Operating humidity | 0–99% RH, non-condensing |
| Location | Indoor only |
| Compatibility | |
| Compatible detectors | Nexelec INSAFE (smoke), Nexelec SECURE (CO) |
| Mounting hole compatibility | Wide range of existing hole spacings from other detector brands |
| Compliance | |
| Applicable standards | EN14604, EN50291, NF292 |
| Ordering | |
| S004-PRO | MOUNT universal mounting base — pack of 50 |
Technical Documents
Contact us for volume pricing, custom pack quantities, or to discuss installation accessories for your deployment.